Magnetic bags are really useful for many projects, and are very easy to wear if you know how. Just follow the steps below to give a perfect shape of your dream magnetic bag clasps wholesaleso give a read to the steps carefully
- You will need a tight clap
- Clasps have a male part
- Clasps also had female half, (guess how they named them!)
- It also had two supporting disks or guards.
Magnetic bag clasps wholesale making
Normally in magnetic bag clasps wholesale making, the male part will be attached under the flap to the lining of the bag, while the female part, the bulk will sit outside the main body of the bag.
The placement of the male part
First, mark the placement of the male part of the magnetic clasp by adding a small dot to the garment with a chalk or a missing pen. Make sure it is far enough away from the edges of the fabric so that you still have room to sew as needed afterwards. If you like you can add a little extra square to tie the line up here just to get extra strength, especially if you want you can use a thin or open knitting fabric.
Place a small metal disc
Now place a small metal disc (guard) over the hole to match the dot that appears in the center, and mark the two cracks on each side with your pen.
Delete disk. You will use two outer lines.
Using a small sharp scissors or a seam ripper, carefully scrape 2 slit marks – just enough to let the prongs pass.
Now turn your piece of line so that the right side is at the top. You should see 2 slits you have created.
Take two pieces of your clasp and choose a small side to attach to the male (yes with a bit out) and push the prongs into the holes.
Re-open the fabric
Re-open the fabric on the wrong side and place a safety disc over the prongs, now bend the prongs outwards to secure the clasp. (You can bend the prongs inside if you like, but they find it too small for the finished bag when it bends outside.) To insert the female part of the clasp follows the same steps.
Desired the location
Mark your desired location with a chalk or a missing pen on the back of the fabric. Add the square of the merger to gain strength. Place a metal disk over the dot and then mark the area of the passage. Carefully cut between slit marks.
The Rotate
Rotate your fabric and insert the prongs on the female part of the clasps through the holes. Add your watch disk to the back side and fold the prongs back for protection. You can buy good quality magnetic bag clasps wholesale at a low price in my store here There, it’s easy when you know how – now go out and add claps to everything without fear!
